With its CENTURIA product line, Tyrolit offers a complete range of conventional, resin-bonded tools for surface grinding. Different face grinding methods are used for rational production of functional surfaces with high requirements relating to evenness, plane parallelism and surface finish. Either both faces are machined simultaneously (double side face grinding), or just one face is machined using single wheels, segments, rings or cups. The components are often manufactured in mass production, which means that there are high requirements with respect to process stability. Show more Show less
COLUMBIA grinding wheels from TYROLIT bridge the technological gap between grinding tools made of fused aluminium oxide and superabrasives. For internal cylindrical grinding applications, in particular, these products of specially bonded sintered aluminium oxide develop their full potential and make possible previously unparalleled levels of performance.
|Product flyer PDF 216 kb|
Through the use of centreless grinding in through-feed and plunge cut grinding, round components can be produced with particular precision and efficiency. Here, the regulating wheel controls the grinding process and therefore has a decisive influence on the quality of the produced components. The CSS REGULATOR from TYROLIT is manufactured as a unitised version. The extremely high compaction ensures uniform quality of the regulating wheel. Show more Show less
|Product flyer PDF 150 kb|
With CSS ULTRA, TYROLIT has managed to restructure the micro-architecture of the grinding wheel with lasting effect by using high quality components and innovative sintering technology. This enables the abrasive grain to withstand much greater loads during use without breaking away prematurely. These improvements result in maximum profile retention combined with minimal wear.
|Product flyer PDF 144 kb|
Honing and superfinishing stones are made from conventional abrasives (aluminium oxide and silicon carbide) as standard. However, Tyrolit also produces these tools using superabrasives (diamond and CBN). Honing and superfinishing is used on components with especially high demands concerning the surface finish and geometry. The demands on the honing and superfinishing stones are also correspondingly high. Show more Show less
With COLUMBIA SA, TYROLIT has created an innovativeproduct line for internal cylindrical and profile grinding withCBN. The VCSA bond, which was specially developedfor this purpose, further enhances the unique propertiesof CBN. The smaller wheel dimensions utilised withininternal cylindrical grinding are particularly suitable for theeconomical use of CBN grinding wheels.
|Product flyer PDF 198 kb|